Zapi AC-2 User Manual download pdf (Page 40)

Page - 40/83 AF2ZP0CE - ACE2 350/450 - User Manual

7) BATT. MAX. ADJ.

It adjusts the upper level of the battery discharge table. It is used to calibrate

the discharge algorithm with the battery of the application. See chapter 9.5

for more information.

8) ADJUSTMENT #03

This parameter adjusts the updating of battery charge after Key-On.

Decreasing this parameter the minimum difference between the battery

voltage measured after Key-On and the last stored value, necessary to

update the charge with the new value measured, decrease. It is used to

calibrate the discharge algorithm with the battery of the application. See

chapter 9.5 for more information.

9) LOAD HM FROM MDI

When set On, the HourMeter of the Controller is transferred and recorded on

the HourMeter of the Standard MDI (connected on the Serial Link).

10) CHECK UP DONE

Turn it On when the required Maintenance service has been executed to

cancel the CHECK UP NEEDED warning.

11) CHECK UP TYPE

It specifies the handling of the CHECK UP NEEDED warning:

- NONE: No CHECK UP NEENED warning

- OPTION#1: CHECK UP NEENED warning shown on the hand set and

MDI after 300 hours

- OPTION#2: Equal to OPTION#1 but Speed reduction after 340 hours

- OPTION#3: Equal to OPTION#2 but the truck definitively stops after 380

hours

12) MAIN CONT VOLT

It specifies the percentage of battery voltage supplied to MC coil to close the

contactor.

13) AUX OUT VOLT

It specifies the percentage of battery voltage supplied to AUX coil to close the

AUXILIARY electro valve.

14) MAIN CONT. V RID

It specifies the percentage of MAIN CONT VOLT parameter, supplied to MC

coil to keep the contactor closed.

Example 1

MAIN CONT VOLTAGE = 100%

MAIN CONT V RID = 70%

The contactor will be closed with full battery voltage applied to the coil and

then the voltage will be reduced to 70% of battery voltage.

Example 2

MAIN CONT VOLTAGE = 70%

MAIN CONT V RID = 100%

The contactor will be closed with 70% of battery voltage applied to the coil

and then the voltage will be kept at the same value.

Example 3

MAIN CONT VOLTAGE = 70%

MAIN CONT V RID = 70%

The contactor will be closed with 70% of battery voltage applied to the coil

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 82 83

Comments to this Manuals

No comments

Zapi AC-2 User Manual Page 40

Comments to this Manuals

Related products and manuals for Power adapters & inverters Zapi AC-2